Mitsubishi cp9500dw User Manual
9
CONNECTIONS
PRECAUTIONS
PREP
CONNECTIONS
CONNECTION WITH SCSI DATA SIGNAL EQUIPMENT
4
0
3
7
2
6
1
5
SCSI ID
Terminator
To SCSI terminal
(Use terminator when no
SCSI device is connceted.)
(Use terminator when no
SCSI device is connceted.)
Digital color printer
To SCSI terminal
To SCSI terminal
Personal computer
2
2
2
2
2
CONNECTING TO PERSONAL COMPUTER (EXAMPLE)
1
1
1
1
1
Press the POWER button to turn on the power.
2
2
2
2
2
Press the DOOR OPEN button to open the door.
3
3
3
3
3
Set the input select switch inside this unit to SCSI.
Push the center of the door to close.
4
4
4
4
4
Press the POWER button to turn off the power.
5
5
5
5
5
Connect the unit and the personal computer with a SCSI cable.
Connect this unit to a personal computer as shown below.
Make sure to turn off the main power of the unit and other equipment before
connection.
Make sure to turn off the main power of the unit and other equipment before
connection.
Input select switch
6
6
6
6
6
Set the SCSI ID switch.
Set the SCSI ID switch on the rear panel according to the personal computer
connected.
•
When some devices with SCSI interface are connected to the personal
computer, do not select the ID number already in use for this printer.
•
Turn the arrow with a screwdriver to set the ID number.
•
The default setting is No. 5.
•
No. 7 is allocated to the personal computer you use and No. 0 is allocated to
the built-in hard disk of the personal computer by default.
7
7
7
7
7
After verifying the connection, press the POWER button to
turn on this unit.
8
8
8
8
8
Turn on the power of the personal computer.