Quantum scalar 100 User Guide
39
ADIC Gateway Setup
2. Attach a bracket (D) to each side of the ADIC Gateway using the small screws
(A) provided with the brackets.
3. Place a washer on each screw (C). Hold the ADIC Gateway in the rack and
secure with four screws.
Figure 3-2: Installation Into a Rack
When mounted in an enclosed rack, provision must be made to exchange 24 CFM
of air between the interior of the rack and the room environment for each ADIC
Gateway installed.
of air between the interior of the rack and the room environment for each ADIC
Gateway installed.
Attaching SCSI Devices
SCSI devices are attached to any of the SCSI connectors on the rear of the ADIC
Gateway. The device types and speeds, as well as cabling, target IDs, and
termination are discussed below. High quality cables with the correct latches or
screws must be used at all times to ensure reliable connections. Cables are not
provided with the ADIC Gateway.
Gateway. The device types and speeds, as well as cabling, target IDs, and
termination are discussed below. High quality cables with the correct latches or
screws must be used at all times to ensure reliable connections. Cables are not
provided with the ADIC Gateway.
Note: Ensure that you read this section before you attach any devices
to the ADIC Gateway. A summary table appears at the end of this
discussion.
discussion.