Meade lx-90 Installation Instruction

The LX90 telescope is shipped with the LNT module attached.
However, the lens for the SmartFinder is shipped unattached
so that it is not damaged or scratched during transport.

1.

The lens for the SmartFinder is shipped with a protective
film to protect the lens coating. Do not remove this film
until told to do so in the instructions. 

First peel back the film from just the “tongue” of the
SmartFinder lens.

2.

Insert the tongue into the SmartFinder slot. Angle the
tongue towards the front of the LNT module as you slide
it into place.

3.

You may need to wiggle the lens/tongue a bit to slide the
tongue into place. You will hear an audible click when the
lens is completely inserted and locked into place.

4.  Remove the remainder of the plastic film from the lens,

but avoid touching the lens as you do so—you may
scratch the lens or leave fingerprints.

5.

To clean the surface of the lens, use a camel hair brush
to gently remove the dust. A high-quality lens cleaning
cloth is also acceptable.

If you have a question concerning use of the Meade

, call the Meade Instruments Customer Service

Department at (949) 451-1450. Customer Service hours are
7:00 AM to 6:00 PM, Pacific Time, Monday through Friday.

For use with Meade LX-90 Series Telescopes

Part no. 14-0670-02     Ver. 11-04

Tongue