Sony STR-DA5600ES User Guide

For example, insert the video tape you 
want to copy into the VCR.

Insert a blank video tape, etc., into the 
recording component (VIDEO 1) for 
recording.

• Some sources contain copy guards to prevent 

recording. In this case, you may not be able to 
record from the sources.

• Analog input signals (audio and composite video) 

are output from the analog output jacks.

• While only composite video signals are being 

recorded, the auto standby function of the receiver 
may start up and interrupt the recording. In this 
case, set “Auto Standby” to “OFF” (page 134).

You can switch the command mode 
(COMMAND MODE AV 1 or COMMAND 
MODE AV 2) of the receiver and the remote.
Switch the command mode from the initial 
setting to the appropriate setting, if other Sony 
component is operated accidentally by the 
same remote, when you are operating the 
receiver using the remote supplied with the 
receiver.
The command modes of both the receiver and 
the remote are those of the initial setting 
(COMMAND MODE AV 2).
The receiver and the remote, on the contrary, 
should use the same command mode. If the 
command modes of the receiver and the 

remote are different, you cannot use the 
remote to operate the receiver.

Press ?/1 to turn off the 
receiver.

While holding down 2CH/
A.DIRECT, press ?/1 to turn on 
the receiver.

When the command mode is set to “AV2,” 
“COMMAND MODE [AV2]” appears on 
the display.
When the command mode is set to “AV1,” 
“COMMAND MODE [AV1]” appears on 
the display.

2CH/A.DIRECT

?/1

DISPLAY

MUTING