Sony STR-DH810 User Guide
95
GB
Ad
ditional Inf
ditional Inf
o
rmation
Troubleshooting
If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem.
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem.
There is no sound, no matter which
component is selected, or only a very
low-level sound is heard.
component is selected, or only a very
low-level sound is heard.
• Check that the speakers and components
are connected correctly and securely.
• Check that all speaker cords are connected
correctly.
• Check that both the receiver and all
components are turned on.
• Check that MASTER VOLUME is not set
to “VOL MIN”.
• Check that the SPEAKERS is not set to
“SPK OFF” (page 34).
• Check that headphones are not connected
to the receiver or S-AIR surround
amplifier.
amplifier.
• Press MUTING (RM-AAP049 only) or
(RM-AAP050 only) on the remote to
cancel the muting function.
• Check that you have selected the correct
component with the input buttons (page
43).
43).
• The protective device on the receiver has
been activated. Turn off the receiver,
eliminate the short-circuit problem, and
turn on the power again.
eliminate the short-circuit problem, and
turn on the power again.
There is no sound from a specific
component.
component.
• Check that the component is connected
correctly to the audio input jacks for that
component.
component.
• Check that the cord(s) used for the
connection is (are) fully inserted into the
jacks on both the receiver and the
component.
jacks on both the receiver and the
component.
There is no sound from one of the front
speakers.
speakers.
• Connect a pair of headphones to the
PHONES jack to verify that sound is
output from the headphones. If only one
channel is output from the headphones, the
component may not be connected to the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the component. If both
channels are output from the headphones,
the front speaker may not be connected to
the receiver correctly. Check the
connection of the front speaker which is
not outputting any sound.
output from the headphones. If only one
channel is output from the headphones, the
component may not be connected to the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the component. If both
channels are output from the headphones,
the front speaker may not be connected to
the receiver correctly. Check the
connection of the front speaker which is
not outputting any sound.
• Make sure you have connected to both the
L and R jacks of an analog component, and
not only to either the L or R jack. Use an
audio cord (not supplied).
not only to either the L or R jack. Use an
audio cord (not supplied).
There is no sound from analog 2
channel sources.
channel sources.
• Check that the INPUT MODE is not set to
• Check that the INPUT MODE is not set to
“AUTO” (page 69) and the “A. ASSIGN”
function is not used to reassign the audio
input of another source to the selected
input (page 69).
function is not used to reassign the audio
input of another source to the selected
input (page 69).
There is no sound from digital sources
(from COAXIAL or OPTICAL input jack).
(from COAXIAL or OPTICAL input jack).
• Check that the INPUT MODE is not set to
• Check that the Analog Direct is not
selected.
• Check that the “A. ASSIGN” function is
not used to reassign the audio input of
another source to the selected input (page
69).
another source to the selected input (page
69).
• Set “ARC” to “ARC OFF” when no sound
is output from TV OPTICAL IN jack
during TV input (page 60).
during TV input (page 60).
Audio
continued