Sony DCR-IP210 User Manual
42
You can monitor the recorded tape on the LCD screen. If you close the LCD panel, you
can monitor the playback picture in the viewfinder. You can also control playback using
the Remote Commander.
can monitor the playback picture in the viewfinder. You can also control playback using
the Remote Commander.
(1) Prepare the power source and insert the recorded tape.
(2) Set the POWER switch to VCR.
(2) Set the POWER switch to VCR.
The VCR lamp lights up.
(3) Open the LCD panel.
(4) Press
(4) Press
to rewind the tape.
(5) Press
to start playback.
(6) Adjust the volume following the steps below.
1
Press FN to display PAGE1 (p. 27).
2
Press VOL. The screen for the volume adjustment appears.
3
Press –/+ to adjust the volume.
– : To decrease the volume
+ : To increase the volume
– : To decrease the volume
+ : To increase the volume
(7) Press
OK. The display returns to PAGE1.
To return to FN
Press EXIT after step 7.
To stop playback
Press
on the LCD screen or STOP on the Remote Commander.
If you leave the power on for a long time
Your camcorder gets warm. This is not a malfunction.
Your camcorder gets warm. This is not a malfunction.
— Playback – Basics —
Playing back a tape
5
4
2
6,7
FN
VOL
MEMOR
Y/NETWORK
CAMERA
POWER
(CHG)
OFF
ON
MODE
VCR
VOL
–
+
OK
Bar indicator