Sony kdl-40xbr7 User Guide
25
O
p
era
ting th
e TV
Programming the Remote
Control
Control
The remote control can be programmed to operate
other equipment and is pre-programmed to operate
the following Sony equipment.
other equipment and is pre-programmed to operate
the following Sony equipment.
Follow the steps below to program your TV
remote control.
remote control.
1
Find the code that corresponds to your
equipment from page 26. If more than one
code is provided, try programming the first
code listed.
equipment from page 26. If more than one
code is provided, try programming the first
code listed.
2
Press and hold DVD, AMP or STB
simultaneously with the INPUT button and
release. When in the programming mode, the
FUNCTION button blinks for approximately
30 seconds until a code is entered.
simultaneously with the INPUT button and
release. When in the programming mode, the
FUNCTION button blinks for approximately
30 seconds until a code is entered.
3
Enter the five digit code using 0-9 while the
FUNCTION button is lit. If the code is not
entered within 30 seconds, you must repeat
step 2.
FUNCTION button is lit. If the code is not
entered within 30 seconds, you must repeat
step 2.
4
Press
or
ENT to confirm the code. If
successfully programmed, the FUNCTION
button blinks twice; if not, it blinks five times.
button blinks twice; if not, it blinks five times.
~
• Any of the FUNCTION buttons can be programmed to
operate other equipment regardless of the labeling. For
example, DVD can be programmed to operate a Blu-
ray player.
example, DVD can be programmed to operate a Blu-
ray player.
Confirm the Programming
If you can turn your equipment on and off using
the green POWER button, the programming is
complete. If not, try the next code listed.
the green POWER button, the programming is
complete. If not, try the next code listed.
~
• In some cases, you may not be able to program your
remote control. If this is the case, use your equipment’s
own remote control.
own remote control.
The backlight can be set to light up when a button
is pressed.
is pressed.
To set backlight:
Press LIGHT and MUTING simultaneously until
the four FUNCTION buttons blink red.
the four FUNCTION buttons blink red.
To turn off backlight:
Press LIGHT and MUTING until the TV button
blinks red.
blinks red.
The remote control can be set to remain lit longer
than the default time setting of approximately five
seconds with the FUNCTION buttons.
than the default time setting of approximately five
seconds with the FUNCTION buttons.
To change backlight time setting:
1
Press LIGHT, VOL+, and then CH+
simultaneously until the FUNCTION button
blinks red.
simultaneously until the FUNCTION button
blinks red.
2
Select the FUNCTION button that corresponds
to your preferred time out setting and press
to your preferred time out setting and press
.
To reset the remote control to the factory default
settings, press SOUND, TV POWER, and then
settings, press SOUND, TV POWER, and then
. The FUNCTION buttons blink red
simultaneously when successfully reset.
Function Button
Sony Equipment Code Number
DVD
DVD Player
31033
AMP
Receiver
52172
STB
Digital Satellite
01639
Programming Other Equipment
DISPLAY
VOL CH
DVD AMP STB
TV
PREV REPLAY
ADVANCE NEXT
THEATER SOUND PICTURE WIDE
CC FREEZE
LIGHT POWER
TV POWER
SYNC MENU
PAUSE
PLAY
FUNCTION
STOP
2
3
2
4
Auto Backlight
Backlight Time Out
DVD 5 seconds (default)
AMP 10 seconds
STB 15 seconds
TV 20 seconds
Reset the Remote Control