LevelOne FBR-4000 User Guide
Page 79
Data
– System Status
WAN Interface
Connection Type
– The type of connection used – DHCP, Fixed IP, PPPoE
or PPTP.
Connection Status
– Either "Connected" or "Disconnected”.
"Force Renew" button
– Only available if using a dynamic IP address
(DHCP). Clicking this button will perform a DHCP "Renew" transaction with
the ISP's DHCP server. This will extend the period for which the current
WAN IP address is allocated to you.
the ISP's DHCP server. This will extend the period for which the current
WAN IP address is allocated to you.
Connect/Disconnect
– Used for dial-up/connection of PPPoE or PPTP.
IP Address
– The IP address of the Multi-WAN VPN Router, as seen from
the Internet. This IP Address is allocated by the ISP (Internet Service
Provider).
Provider).
Subnet Mask
– The Network Mask (Subnet Mask) for the IP Address above.
Domain Name IP Address
– The address of the current DNS (Domain
Name Server)
Gateway
– The address of the Multi-WAN VPN Router gateway.
MAC Address
– The MAC (physical) address of the Multi-WAN VPN
Router, as seen from the Internet.
LAN Interface
IP Address
– The LAN IP Address of the Multi-WAN VPN Router.
Subnet Mask
– The Network Mask (Subnet Mask) for the IP Address above.
MAC Address
– The MAC (physical) address of the Multi-WAN VPN
Router, as seen from the local LAN.
DHCP Server
– The status of the DHCP Server function - either "Enabled"
or "Disabled".
Device
Information
Information
Hardware ID
– The manufacturers ID for this particular device.
Firmware Version
– Version of the Firmware currently installed.
NAT
– Status of the NAT feature – either “Enable” or “Disable”.
Load Balance
– Status of the Load Balance feature – either “Enable” or
“Disable”.
Virtual Server
– Status of the Virtual Server feature – either "Enabled" or
"Disabled".
Special Applications
– Status of the Special Applications feature – either
"Enabled" or "Disabled".
Multi DMZ
– Status of the Multi DMZ feature – either "Enabled" or
"Disabled".
Block URL
– Status of the Block URL feature – either “Enable” or “Disable”.