Roland v-synth xt Owner's Manual
28
Try Out the Sounds
Selecting Patches and Playing Sounds
The V-Synth XT comes with a wide range of onboard sounds, including single tones
called patches. Let’s select a few patches to get an idea of the variety of sounds
available with the V-Synth XT.
called patches. Let’s select a few patches to get an idea of the variety of sounds
available with the V-Synth XT.
1
Make sure the PATCH PLAY screen is displayed.
If the PATCH PLAY screen—shown below—is not displayed, press [EXIT] once or
twice until the PATCH PLAY screen appears.
twice until the PATCH PLAY screen appears.
fig.Q-06.e
2
Press the [PREVIEW] button to audition the patch.
3
To change to a different patch, touch the patch number to highlight it,
and then turn the VALUE dial or press [INC] [DEC]. At this time you
can switch more rapidly by holding down [SHIFT] while you perform
these operations.
fig.Q-06a
Patch number
To change the preview type,
hold down [SHIFT] while you
press [PREVIEW].
hold down [SHIFT] while you
press [PREVIEW].
• The preview will play while
you hold down [PREVIEW].
• The button will blink when
you press [PREVIEW], and
the preview will play. Press
[PREVIEW] once again to
stop play.
the preview will play. Press
[PREVIEW] once again to
stop play.
You can also touch the patch
number display area and use
the numeric keys to switch
patches (p. 27).
number display area and use
the numeric keys to switch
patches (p. 27).
Alternately, you can touch the
patch number and drag your
finger up and down—or right
and left—to change patches.
patch number and drag your
finger up and down—or right
and left—to change patches.
V-SYNTH_XT_e2 28 ページ 2005年3月23日 水曜日 午後4時39分