Apex at1308 Instruction Manual

7

- Please read the safety instructions in this manual completely before installation.

- Install your TV in an area where direct sunlight will not fall upon the screen. 

- Soft, indirect light is best for television viewing.

- Allow enough space (at least 4 in.) between the TV and any walls or enclosures for proper ventilation.

- Optimum television viewing distance is 3-5 times the screen's size.

Color television can be easily affected by magnetism, which shows as color distortion on the screen. If your TV is

affected by nearby magnetic components or appliances, turn it off for a few minutes. The built-in auto-degaussing

circuit will eliminate the magnetic interference.

The TV set will automatically enter into Standby mode when the following conditions are met.

1.TV is in antenna mode.

2.Current channel has no signal.

3.No key is pressed within 15 minutes.

75-ohm coaxial cable (not supplied)

300-ohm twin-lead cable (not supplied)

OR

Antenna adapter

(not supplied)

VHF

UHF

or Cable

VHF

UHF

RF Input 

(back of TV unit)

Instruction Manual

OR

U/V mixer

(not supplied)

1. It is recommended that a 75 ohm coaxial cable be used in order to

eliminate interference and noise which may occur due to nearby radio

transmissions. 

2. The antenna cable should not be tied together with other wiring.

3. Set up a lightning rod and check it regularly when an outdoor antenna

is used. 

1. Remove the battery compartment lid.

2. Insert two AAA batteries (included). Make sure the positive (+) and

negative (-) polarities are correctly aligned.

3. Reattach the battery lid.

1. Alkaline batteries are recommended for longer life. 

2. Always replace both batteries at the same time. 

3. Do not expose batteries to fire or break them open.

4.To avoid battery leakage, remove batteries from the remote control

when it is not being used for a long period of time.