Intel Desktop Board D945GRW KD945GRWLKPAK10 User Manual
Product codes
KD945GRWLKPAK10
Intel Desktop Board D945GRW Technical Product Specification
50
2.5 PCI Configuration Space Map
Table 13. PCI Configuration Space Map
Bus
Number (hex)
Number (hex)
Device
Number (hex)
Number (hex)
Function
Number (hex)
Number (hex)
Description
00
00
00
Memory controller of Intel 82945G component
00
01
00
PCI Express x16 graphics port
(Note 1)
00 02 00 Integrated
graphics
controller
00
1B
00
Intel High Definition Audio Controller
00
1C
00
PCI Express port 1
00
1C
01
PCI Express port 2
00
1C
02
PCI Express port 3
00
1C
03
PCI Express port 4
00
1D
00
USB UHCI controller 1
00
1D
01
USB UHCI controller 2
00
1D
02
USB UHCI controller 3
00
1D
03
USB UHCI controller 4
00 1D 07 EHCI
controller
00 1E 00 PCI
bridge
00 1F 00 PCI
controller
00
1F
01
Parallel ATA IDE controller
00 1F 02 Serial
ATA
controller
00 1F 03 SMBus
controller
(Note 2)
00 00 Gigabit
LAN
controller
(Note 2)
05
00
IEEE-1394a controller (if present)
01 00 00 PCI
Express
video
controller
(Note 1)
Notes:
1.
Present only when a PCI Express x16 graphics card is installed.
2.
Bus number is dynamic and can change based on add-in cards used.
2.6 Connectors
CAUTION
Only the following connectors have overcurrent protection: back panel USB, front panel USB, and
PS/2. The other internal connectors are not overcurrent protected and should connect only to
devices inside the computer’s chassis, such as fans and internal peripherals. Do not use these
connectors to power devices external to the computer’s chassis. A fault in the load presented by the
external devices could cause damage to the computer, the power cable, and the external devices
themselves.
PS/2. The other internal connectors are not overcurrent protected and should connect only to
devices inside the computer’s chassis, such as fans and internal peripherals. Do not use these
connectors to power devices external to the computer’s chassis. A fault in the load presented by the
external devices could cause damage to the computer, the power cable, and the external devices
themselves.
This section describes the board’s connectors. The connectors can be divided into these groups:
• Back panel I/O connectors (see page 51)
• Component-side I/O connectors (see page 52)
• Component-side I/O connectors (see page 52)