Enterasys 6000 User Guide

Completing the Installation

Installation

Examine the module for damage. If any damage exists, DO NOT install the module. 
Immediately contact Cabletron Systems.

Caution: To prevent damaging the backplane connectors in the following step, take care that the 
module slides in straight and properly engages the backplane connectors. 

Ensure that the top plastic locking tab lines up with the desired slot number located on the front 
panel of the chassis. Refer to 

Locate the slot guides that line up with the number of the slot in which the module will be 
installed. Install the module in the chassis by aligning the module circuit card between the upper 
and lower metal rail guides of the desired slot, sliding it into the chassis, and locking down the 
top and bottom plastic locking tabs, as shown in 

. Take care that the module slides in 

straight and properly engages the backplane connectors.

If the chassis in which the module is installed was powered down for the installation, turn it 
back on. Check to see that the CPU LED settles at solid green after a few minutes. If the LED 
does not turn solid green, see 

Chapter 5

 for details. 

After installing the 6SSRM-02 proceed as follows:

If the chassis is installed in a rack that has strain-relief brackets, secure the cables by running 
the cables along the strain-relief bracket and tying them to the bracket using cable ties. 

The 6SSRM-02 is now ready to be configured through the CLI interface. Refer to the Command 
Line Interface Guide and the User Reference Guide for configuration information.