Enterasys mrxi-22 User Guide
3-1
CHAPTER 3
INSTALLATION
This chapter outlines the procedure for installing your MRXI and
connecting it to a network. Ensure that your network meets the
guidelines and requirements outlined in Chapter 2, Installation
Requirements/Specifications, before installing the MRXI.
connecting it to a network. Ensure that your network meets the
guidelines and requirements outlined in Chapter 2, Installation
Requirements/Specifications, before installing the MRXI.
3.1
UNPACKING THE MRXI
Unpack the MRXI as follows:
•
Remove the two plastic bags containing the accessories.
•
Remove the MRXI from the shipping box.
•
Slide the two foam end caps off the MRXI.
•
Remove the MRXI from the protective plastic bag and set it aside to
prevent damage.
prevent damage.
Before you install the MRXI visually inspect the unit and check the
contents of the accessory package. Contact Cabletron Systems Technical
Support immediately if you find any discrepancies.
contents of the accessory package. Contact Cabletron Systems Technical
Support immediately if you find any discrepancies.
3.2
ATTACHING THE STRAIN RELIEF BRACKET
Attach the strain relief bracket to the front of the MRXI as follows:
1. Locate the strain relief bracket and four 8-32 x 3/8” screws from the
MRXI installation kit.
Warning: Use of longer screws may cause damage to the unit or
electrical shock.
electrical shock.
2. Attach the strain relief bracket to the bottom of the MRXI as shown in
Figure 3-1.