Enterasys a2h123-24 User Manual
Connecting AC and RPS-SYS Power
3-12
Hardware Installation
Connecting AC and RPS-SYS Power
AC Power
To connect a switch to the AC power source, refer to
1.
Plug the power cord
into the switch AC power connector.
2.
Plug the other end of the power cord into a dedicated grounded AC outlet (not
shown). The type of power outlet and power cord are country‐dependent.
shown). The type of power outlet and power cord are country‐dependent.
Note: The power supply in the switch has automatic voltage sensing that allows
connection to power sources ranging from 100 to 240 VAC.
connection to power sources ranging from 100 to 240 VAC.
Note: If you plan to connect all the switches quickly to allow automatic Manager selection,
wait until all switches are fully operational before proceeding to the next step.
wait until all switches are fully operational before proceeding to the next step.
If you plan to power up each switch and allow it to become fully operational before
applying power to the next switch, proceed to the next step.
applying power to the next switch, proceed to the next step.