Enterasys a2h123-24 User Manual
Connecting to Console Port for Local Management
3-18
Hardware Installation
When these parameters are set, the Startup screen will display. Proceed to “
Figure 3-10
Connecting a VT Series Terminal
Connecting to a Modem
To connect a modem to an Enterasys Networks switch modem port (
), use a
UTP cable terminated with a DB9 female connector and a DB25 male connector, and
proceed as follows:
proceed as follows:
1.
Connect the DB9 female connector at one end of the cable to the Console port DB9
connector on the Enterasys switch. (If there is a switch designated as the Manager,
connect to its Console port.)
connector on the Enterasys switch. (If there is a switch designated as the Manager,
connect to its Console port.)
2.
Plug the DB25 male connector at the other end of the cable into the modem
communications port.
communications port.
3.
Turn on the modem and make sure the remote modem is ON.
4.
With your PC connected to the remote modem, configure your VT emulation package
with the following parameters:
with the following parameters:
1 DB9 female connector
4 DB25 female connector
2 Serial interface cable
5 PC with VT emulation application
3 DB9 male Console port connector
Â
Ã
Á
À
Ä
Console
CPU
UP
RPS
MGR
DOW
N
Parameter
Setting
Mode
7 Bit Control
Transmit
Transmit=9600
Bits Parity
8 Bits, No Parity
Stop Bit
1 Stop Bit