Enterasys 9500 Installation Instruction

 

Installing the 9A686-04 Module

2-4

 

An eight-position DIP switch is located on the module card as shown in 
Figure 2-3. The functions of the switches are listed in Table 2-1.

 

Do not toggle Switch 8 unless you intend to reset the user -configured passwords 
to their factory default settings.

Do not toggle Switch 7 unless you intend to reset the user parameters to the 
factory default settings. Refer to the

 

for instructions on the parameters that may be configured by the user using 
Local/Remote Management.

 

8

Clear 

Password

 

 

 

When toggled, this switch clears user-entered 
passwords stored in NVRAM, and restores the 
default passwords. Once reset you can use the 
defaults or enter new passwords.

7

Clear 

NVRAM

 

 

 

The module uses NVRAM to store user 
entered parameters such as IP addresses, 
device name, etc. To reset these parameters to 
the factory defaults, toggle this switch. Once 
reset you can use the defaults or enter new 
parameters which are stored in NVRAM when 
the module is powered down, and remain 
there until the switch is toggled again.

6

Force BootP 

Download

Toggling this switch after pulling the board 
out of the SmartSwitch 9500, clears download 
information from NVRAM and forces image 
files to be downloaded from the station 
connected to the EPIM on the Environmental 
Module configured to act as that modulesÕ 
B

 

OOT

 

P server.

5

Reserved

For Factory Use Only

4

Reserved

For Factory Use Only

3

Reserved

For Factory Use Only

2

Reserved

For Factory Use Only

1

Reserved

For Factory Use Only