Nokia 8210 Supplementary Manual

AT Command Set for Nokia 8210

Syntax:

AT+IFC=<DCE_by_DTE>,
<DTE_by_DCE>

Set flow control.
Default is 2,2.

AT+IFC?

Query current setting.
Response is +IFC: <DCE_by_DTE>,
<DTE_by_DCE>.

AT+IFC=?

Show valid range of parameters.
Response is+IFC:(list of supported
<DCE_by_DTE>'s), (list of supported
<DTE_by_DCE>'s)

Parameters:

<DCE_by_DTE>
0

no flow control

XON/XOFF (software) flow control

CTS/RTS (hardware) flow control

both XON/XOFF and CTS/RTS flow
control

<DTE_by_DCE>
0

no flow control

XON/XOFF (software) flow control

CTS/RTS (hardware) flow control

+ILRR DTE-DCE Local Rate Reporting

This command controls whether or not the +ILRR:<rate> information text is
transmitted to the DTE. If enabled, the result code is transmitted after any
modification, error control or data compression reports are transmitted, and before
any final result code (e.g., CONNECT) is transmitted. The <rate> is applied after the
final result code is transmitted. (V.25ter section 6.2.13.)

Syntax:

AT+ILRR=<mode>

Set reporting mode.
Default is 0.

AT+ILRR?

Query current setting.
Response is +ILRR: <mode>.

AT+ILRR=?

Show supported values.
Response is +ILRR:(list of supported
<mode>'s)

Values for <mode>:

local port rate reporting disabled

local port rate reporting enabled

+IPR Fixed DTE Rate

This command specifies the data rate at which the product will accept commands.
Command must be in products that do not support autobauding in all configurations
and have more the one <rate> to be set (either 1200 or 9600 is mandatory according
to V.25ter). Note that reset commands Z and &F do not change this setting.

Syntax:

AT+IPR=<rate>

Set DTE rate. Default is [0].

AT+IPR?

Query current setting.
Response is +IPR: <rate>.

AT+IPR=?

Show valid range of rate.
Response is +IPR:(list of supported
<rate>'s).