TiVo Series2 Network Guide
2
Connecting Your DVR to Your Home Network
11
Connecting to a Home Network Using a
Wireless Network Adapter
Wireless Network Adapter
Use this example if you have a home network that includes a wireless
access point or wireless router, or for each DVR in a wireless peer-to-peer
network. You can leave your DVR plugged in while you connect a network
adapter.
access point or wireless router, or for each DVR in a wireless peer-to-peer
network. You can leave your DVR plugged in while you connect a network
adapter.
To connect a wireless network adapter to your TiVo Series2 DVR:
1. Connect to the adapter. If it is not already attached, connect one end of
the USB cable that came with your wireless network adapter to the port
located on the back of the adapter.
located on the back of the adapter.
2. Connect to the DVR. Connect the other end of the USB cable to the USB
port on the TiVo Series2 DVR. The power light on the wireless adapter
may come on before the cable is completely inserted into the USB slot.
Make sure you push the cable all the way into the USB slot.
may come on before the cable is completely inserted into the USB slot.
Make sure you push the cable all the way into the USB slot.
3. Position the adapter. Position the adapter in an open location so that the
signal is easily transmitted. For example, if your DVR is in an
entertainment center, you might place the adapter on top of your
entertainment center. Do not place the wireless adapter near the TiVo
DVR’s power supply or on a power strip or surge protector. Doing so
can cause signal interference or reduce signal strength.
entertainment center, you might place the adapter on top of your
entertainment center. Do not place the wireless adapter near the TiVo
DVR’s power supply or on a power strip or surge protector. Doing so
can cause signal interference or reduce signal strength.
4. Firmware update. When you first connect a wireless network adapter to
your TiVo Series2 DVR, you may see a screen that says “Firmware
Update Required.” This means your DVR has a software update for the
wireless network adapter you have connected. Select the option to
update. This should not take more than a minute or two.
Update Required.” This means your DVR has a software update for the
wireless network adapter you have connected. Select the option to
update. This should not take more than a minute or two.
During the update, do not disconnect the network adapter wires or the
power to the TiVo Series2 DVR. Either action might damage the adapter.
power to the TiVo Series2 DVR. Either action might damage the adapter.
5. Important message. The first time you press the TiVo button after you
connect a network adapter, you will see an Important Message. Review
it, then press SELECT on the TiVo remote to go to TiVo Central.
it, then press SELECT on the TiVo remote to go to TiVo Central.
The cable may already be attached
to your wireless network adapter.
®