Pro-Team coachvac User Guide
– ProTeam Owner’s Manual
EN
G
LI
SH
Preventative Maintenance
WARNING:
The following information is for use by qualified service personnel only and
provides guidance for troubleshooting and maintenance.
•
Unplug the vacuum when working on the motor or any electrical part.
• Have a qualified service person at an authorized ProTeam Warranty Station check the
carbon brushes on the motor every six months and replace any brush worn down to
1/2” in length. If carbon brushes are not checked and replaced to maintenance
schedule listed on pg. 5, warranty will be void.
1/2” in length. If carbon brushes are not checked and replaced to maintenance
schedule listed on pg. 5, warranty will be void.
• Do not lubricate the motor.
• Do not tie extension cord and power cord together. Doing so will result in
damage to both cords and will not be covered under warranty.
CARING FOR YOUR VACUUM
1. To ensure a valid vacuum warranty, optimal performance and improved indoor
air quality, be sure to use genuine ProTeam Intercept Micro Filters.
2. Check the filters before each use. Empty or replace the filters as necessary.
3. Rinse, air dry, and reinsert the foam/filter diffuser each week.
4. Wipe the inside and outside of the vacuum with a household cleaning agent
after each use.
PROPER STORAGE
Store the vacuum in a dry place when not in use.
TROUBLESHOOTING
1. If the vacuum will not operate, check the following:
a. The power supply cord at the wall outlet
b. The power supply cord at the vacuum
c. That the switch is in the “on” position and functioning properly
b. The power supply cord at the vacuum
c. That the switch is in the “on” position and functioning properly
2. If the pigtail (18” power cord) is getting warm, check to see that the extension cord
does not exceed a length of 50 feet at 16 gauge or 100 feet at 14 gauge.
Longer cords will overheat and damage the vacuum.
Longer cords will overheat and damage the vacuum.
3. If the exhaust that comes out of the bottom of the vacuum is warmer than usual,
check and clean all four filters.
4. If the power switch fails, check the circuit breaker. If that is not the problem, call a
ProTeam Warranty Station.
5. If loss of suction occurs, check the following:
a. Check that debris is not plugging the hose, wand, and/or floor tool.
b. Check and/or clean both Intercept Micro Filter and Cloth Filters.
c. Check that the hose cuffs are fitting tightly on the hose and are not cracked.
d. Check that the cap is properly attached to the vacuum body.
e. Check that the Dome filter hasn’t shifted and is securely in place.
b. Check and/or clean both Intercept Micro Filter and Cloth Filters.
c. Check that the hose cuffs are fitting tightly on the hose and are not cracked.
d. Check that the cap is properly attached to the vacuum body.
e. Check that the Dome filter hasn’t shifted and is securely in place.