Denon AVP-A1HD User Manual

• Insert the AC plugs securely. Incomplete connections could cause noise.
• Only use the AC outlets to plug in audio devices. Do not use them as power supplies for hairdryers or 

anything other than audio equipment. In addition, do not connect audio devices such as high electricity 
consumption power amplifiers (e.g. POA-A1HDCI).

Wait until all connections have been completed before connecting the power cord.

To household 

power outlet

(AC 120 V, 60 Hz)

Power cord 

(included)

• These  outlets  supply  power  to  external  audio 

devices.

• The power supplied from this outlets turns on and 

off together with the set’s power switch.

• Audio equipment with a total power consumption 

of 120 W (1 A) can be connected.

The  power  of  an  external  device  equipped  with 
a  trigger  input  jack  can  be  turned  on  and  off  in 
association with operations on the AVP-A1HDCI. 
For  details,  see  GUI  menu  “Manual  Setup”  – 
“Option Setup” – “Trigger Out 1”, “Trigger Out 2”, 
“Trigger Out 3” or “Trigger Out 4” (vpage 42).
• Output level: 250 mA/12 V

Check  the  trigger  input  conditions  of  the 
connected device.

• When  using  in  combination  with  an  RF  Remote  Controller  (RC-7000CI,  sold  separately)  and  RF  Remote 

Receiver (RC-7001RCI, sold separately) two-way communication with an RF Remote Controller is possible.

  The AVP-A1HDCI’s status information as well as iPod and Internet audio music files can be browsed 

watching  the  RF  Remote  Controller’s  display.  For  details,  refer  to  the  operating  instructions  of  the 

respective devices.

• When used in combination with an RF Remote Controller and RF Remote Receiver, make the settings at 

GUI menu “Manual Setup” – “Option Setup” – “2Way Remote” – “Used” (vpage 42).

• When using the 2-way remote control unit, connect to the Port 1 RS-232C connector.
• If GUI menu “Manual Setup” – “Option Setup” – “2Way Remote”is set to “Used”, you cannot use port 

1 of the RS-232C connector for the external controller.

This connector is used for an external controller.

b

  If  you  use  an  external  controller  to  operate 

the  unit  via  the  RS-232C  terminal,  you  must 
confirm the following beforehand.

q

  Turn on the AVP-A1HDCI’s power.

w

  Turn  off  the  AVP-A1HDCI’s  power  from  the 

external controller.

e

  AVP-A1HDCI enters the standby status.

 (vpage 58)