Denon dbp-1611 User Guide

22

This section is for making the settings for television resolution. Set them depending on the connected 
television. 

• The resolution is changed as shown below each time the 

 button is pressed. 

• The default settings is underlined.

Auto

480/576i

1080P24

1080P

1080i

480/576P

720P

Source Direct

(Auto)

(1080 progressive, 24-frame)

(Source direct)

(1080 progressive)

(480/576 interlaced)

(1080 interlaced)

(480/576 progressive)

(720 progressive)

• This unit’s component video output supports 480i/576i/480p/576p/720p/1080i output 
• If the Video resolution is not set to “Auto”, set it to correspond with the resolution of your television.
• Images will not be projected normally if the television resolution and this unit’s output resolution do not 

match.

• Audio and video will be temporarily interrupted if the power of the connected device currently playing is 

turned off, or the input is switched.

• When you change the HDMI video resolution of the unit, it takes a few seconds up to about 10 seconds 

for validation between the unit and the connected device. Audio/video is not output during this period.

• When the HDMI video resolution is set to “1080P24”, a HDMI video signal is output from the unit with a 

resolution of 1080P and a frame rate of 24 frames per second, regardless of the video signal on the disc 
being played. Because of this, when playing discs containing video signals recorded with a frame rate 
of something other than 24 frames per second, the movement of the picture may be unnatural. If this 
happens, set the HDMI video resolution to something other than “1080P24”.

• When you make the following settings, this unit will output video signals from an HDMI OUT connector 

with a resolution of 1080P24.

• RESOLUTION setting: Set to “Auto”, “Source Direct”, or “1080P24”.
• HDMI mode setting: Set to “24P ON”.
• Television resolution supports 1080P24.

Under these setting conditions, no video signals are output from VIDEO OUT and COMPONENT VIDEO 
OUT connectors. To output video signals, press 

 and set HDMI output to “24P OFF”.

Most movies on Blu-ray disc are recorded at 24 frames per second, the same as movie film. 
If the unit is set like this, images with the same quality as movies can be enjoyed. 
The setting for outputting signals with 24 video frames in HDMI mode is made here. Then images with 
fluid motion can be enjoyed when video of 1080P24 is played. 

You can not use HDMI MODE while the GUI menu is displayed.

• The current status of HDMI output is displayed on the television screen. 
• Each time 

 MODE

 is pressed, “24P ON” and “24P OFF” are toggled. 

• The default setting is “24P OFF”. 

• If the connected television supports “1080P24”, use this setting. 
• After making settings, set Video Resolution to “1080P24” or “SourceDirect”. 

• If the connected television does not support “1080P24”, use this position. 

1.DBP-1611E3_ENG_0702.indd   22

2010/07/05   17:24:20