Rocketfish RF-RBWS02 User Guide
7
RF-RBWS02
Front panel
#
Feature
Description
1
Power/Join button
Press to turn the sender/receiver on, then hold to initiate joining. Press again to go into
standby. Upon insertion of the AC adapter, the unit powers up automatically.
standby. Upon insertion of the AC adapter, the unit powers up automatically.
2
Power/Join indicator
Lights blue when the HUB STATUS is set to “DISABLE”.
Lights green when the HUB STATUS is set to “ENABLE”.
The LED will show a solid illumination when it is joined in a network, if the unit is not in a
network the LED will flash slowly. When the unit is put in joining mode the LED will flash
rapidly.
Lights green when the HUB STATUS is set to “ENABLE”.
The LED will show a solid illumination when it is joined in a network, if the unit is not in a
network the LED will flash slowly. When the unit is put in joining mode the LED will flash
rapidly.
3
Standby LED
Turns red when the sender/receiver is in standby mode.
4
IR sensor window
Receives the signal from the remote control.
5
Source
Press the next source button to move to the next source. Each press of the button will toggle
to the next source.
to the next source.
6
Receiver-mode LED
Turns blue when receiving signals. Note: This LED will not be lit if the source unit is turned off
or is no longer sending audio. Press the Source button to find the next available source.
or is no longer sending audio. Press the Source button to find the next available source.
7
Sender-mode LED
Turns blue when sending signals. Note: This LED will light automatically when a 3.5 mm
connector is attached to the unit, as the device senses the cable connection.
TM
1
2
3
4
5
6
7
RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 7 Thursday, August 27, 2009 7:39 PM