NEC fp912sb-bk User Manual

 7

 Eliminates picture impurities that may result from the

earth’s magnetic field. While in the sub-menus (TL: Top Left, TR: Top Right, BL:
Bottom Left, BR: Bottom Right) use the –/+ control buttons to fine tune the
GlobalSync corrections.
NOTE:

NEC recommends that you perform GlobalSync correction while
running a typical application such as a spreadsheet or text document.

 OSM controls menus are available in six languages.

 You can choose where you would like the OSM controls menu to

appear on your screen. Selecting OSM Position allows you to manually adjust the

OSM controls menu left, right, up or down.
OSM Turn Off:

 The OSM controls menu will stay on as long as it is in use.  In the

OSM Turn Off sub-menu, you can select how long the monitor waits after the last

touch of a button for the OSM controls menu to disappear. The preset choice is in

5 seconds step between 5–120 seconds.

: This control completely locks out access to all OSM controls

functions except Brightness and Contrast. When attempting to activate OSM

controls while in the lock out mode, a screen will appear indicating that OSM

controls are locked out. To activate the OSM Lock Out function, press SELECT, then

press + and hold down simultaneously. To deactivate the OSM Lock Out, press

, then press + and hold down simultaneously.

Enable: The IPM System works normally and all

stages of energy savings are utilized.

Disable: The Off Mode reset

For standard systems and graphics boards, keep the factory setting at ENABLE.

Don’t keep the monitor on when ‘No Signal’ is applied.  This could cause image burn
in on the screen due to the ‘No Signal’ message being displayed.

 Operating your monitor at a nonstandard timing may cause

images to appear darker than normal or have color distortion.  Use of the

EdgeLock control will adjust images to their normal state.
Hot Key:

 This selection allows you to use              as brightness control and –/+

as contrast control.
Factory Preset:

 Selecting Factory Preset allows you a reset most OSM

™

 control

settings back to the factory settings.  A warning statement will appear to confirm

that you do want to reset ALL settings.  Individual settings can be reset by high-

lighting the control to be reset and pressing the RESET button.

Indicates the current mode and frequency setting of the monitor.

Indicates the model and serial numbers of your monitor.

A message will advise you if the refresh rate of the signal being

applied to the monitor by the computer is too low. For further information, please
refer to your display card or system manual.

MSFP912SBManual.p65

8/5/02, 2:09 PM

7