NEC 42VP4 User Manual
1
Drawing B
50
mm
(2")
50
mm
(2")
50
mm
(2")
Wall
Wall
50
mm
(2")
50
mm
(2")
You can attach your optional mounts or stand to the plasma
monitor in one of the following two ways:
monitor in one of the following two ways:
* While it is upright. (See Drawing A)
* As it is laid down with the screen face down (See Drawing
* As it is laid down with the screen face down (See Drawing
B). Lay the protective sheet, which was wrapped around
the monitor when it was packaged, beneath the screen
surface so as not to scratch the screen face.
the monitor when it was packaged, beneath the screen
surface so as not to scratch the screen face.
* Do not touch or hold the screen face when carrying the
unit.
• This device cannot be installed on its own.
Be sure to use a stand or original mounting
unit. (Wall mount unit, Stand, etc.)
unit. (Wall mount unit, Stand, etc.)
* See the inside of the cover page.
• For correct installation and mounting it is
strongly recommended to use a trained,
authorized dealer.
authorized dealer.
Failure to follow correct mounting
procedures could result in damage to the
equipment or injury to the installer.
procedures could result in damage to the
equipment or injury to the installer.
Product warranty does not cover damage
caused by improper installation.
caused by improper installation.
Ventilation Requirements for
enclosure mounting
enclosure mounting
To allow heat to disperse, leave space between
surrounding objects as shown on the diagram
below when installing.
surrounding objects as shown on the diagram
below when installing.
How to Attach Options to the Plasma Monitor
Drawing A
* Use only the mounting kit or stand provided
by manufacturer and listed under Options.