NEC lt100 User Manual
Settings for Monitor Mode
Number of DIP switch
Monitor size
15” multi-scan mode /16”–13”
17” multi-scan mode /19”–13”
19” multi-scan mode /21”–13”
13” fixed mode /640
2480
VGA/SVGA mode
16” fixed mode /832
2624
19” fixed mode /1024
2768
47
INSTALLATION
48
S1
ON
ON
ON
ON
S2
S3
S4
ON
S5
ON
ON
S6
ON
S7
ON
S8
ON
NOTE: For setting other than display modes supported by your Macintosh and LT81/LT100, using of the
DIP switch may bounce a image slightly or may display nothing. If this happens, set the DIP switch to the
13” fixed mode and then restart your Macintosh. After that, restore to a displayable mode and then
restart the Macintosh again.
DIP switch may bounce a image slightly or may display nothing. If this happens, set the DIP switch to the
13” fixed mode and then restart your Macintosh. After that, restore to a displayable mode and then
restart the Macintosh again.
Make sure that LT81/LT100 and your Macintosh are connected with the pin adapter and the supplied
signal cable (mini D-Sub 15-pin connector) and then restart your Macintosh.
signal cable (mini D-Sub 15-pin connector) and then restart your Macintosh.
NOTE: Refer to your computer's owner's manual for more information about your computer's video
output requirements and any special identification or configuring your projector's image and monitor
may require.
output requirements and any special identification or configuring your projector's image and monitor
may require.
ON
ON
→
1 2 3 4 5 6 7 8
ON
→
1 2 3 4 5 6 7 8
19” fixed mode
17” multi-scan mode
VGA/SVGA mode
Examples of DIP switch setting
→
1 2 3 4 5 6 7 8