Sony dav-hdx277 Manual

masterpage:Right

specdef v20070110

filename[E:\SS2008\Models\DCR2WC-2W-4WF\3283032111\3283032111_DAV-HDX277WC-
279W-576WF\gb08ext.fm]

 model name [DAV-HDX277WC / HDX279W / HDX576WF]

 [3-283-032-11(1)]

X/x to select [S-AIR SETUP t], 

X/x to select [PAIRING], then 

The confirmation display appears.

C/c to select [YES], then press 

The unit starts pairing.
To not perform pairing, select [NO].

x For the surround amplifier

Press POWER on the surround amplifier to 
turn on the surround amplifier and press 
PAIRING on the rear panel of the surround 
amplifier.
The PAIRING indicator of the surround 
amplifier flashes red when pairing starts.
When sound transmission is established, 
the PAIRING indicator of the surround 
amplifier turns red and the confirmation 
display appears.

• To press PAIRING on the rear panel of the 

surround amplifier, a slim instrument, such as a 
paper clip, can be used.

x For the S-AIR receiver

Refer to the operating instructions of the 
S-AIR receiver.
When sound transmission is established, 
the confirmation display appears.

• Perform the pairing within several minutes after 

Step 10. If you do not, the pairing is canceled 
automatically and the confirmation display 
appears. To perform pairing, select [YES]. To 
return to the previous display, select [NO].

C/c to select the next operation.

x To finish pairing

Select [NO], then press 

.

x To perform pairing of another S-AIR 
sub unit

Select [YES], then press 

.

• If you perform the pairing operation between the unit 

and another S-AIR sub unit (page 86), sound 
transmission established by ID is canceled.

• When you perform pairing, [(PAIRING)] appears 

beside ID on the display for selecting ID.

Perform the ID setting of the unit according to 
the procedure of “To set the ID of the unit.” If 
you select a new ID (you can select the same ID 
as before), pairing is canceled.

If you use multiple wireless systems which 
sharing the 2.4 GHz band, such as wireless LAN 
or Bluetooth, the transmission of S-AIR 
products or other wireless systems may be 
unstable. In this case, the transmission may be 
improved by changing the following “RF 
CHANGE” setting.

X/x repeatedly until “RF 

c.

X/x to select the desired setting.

• “AUTO”: Normally select this. The 

system change “RF CHANGE” to “ON” 
or “OFF” automatically.

• “ON”: The system transmits sound by 

searching the better channel for 
transmitting.

• “OFF”: The system transmits sound by 

fixing the channel for transmitting.

The setting is made.

The system menu turns off.

When you set “RF CHANGE” to “OFF,” 
select the ID so that sound 
transmission is most stabilized 
(page 83).

• When the wireless transceiver is not inserted in the 

unit, you cannot set the “RF CHANGE.”