Cyberhome dvd 300 Quick Setup Guide
Use the AV (Audio/Video) cable
provided to connect the DVD player to
your TV as shown in the diagram.
your TV as shown in the diagram.
Your TV must be equipped with AV
inputs like those pictured to the right in
order to connect this unit.
order to connect this unit.
If your TV does not have AV inputs, you
will need a RF Modulator to connect this
player to your TV's antenna/cable input.
RF Modulators are available at major
electronics retailers.
player to your TV's antenna/cable input.
RF Modulators are available at major
electronics retailers.
Connect the DVD Player to
your TV
your TV
1
CH-DVD 300 Quick Setup Guide
The goal is to see the DVD player's splash screen on your
TV. To do this, select the Video Input channel on your TV
that corresponds with the input the player is plugged into.
This procedure differs among TVs, but is normally done by
pressing the VIDEO IN or INPUT button on the TV's remote
control to select the Video Input.
that corresponds with the input the player is plugged into.
This procedure differs among TVs, but is normally done by
pressing the VIDEO IN or INPUT button on the TV's remote
control to select the Video Input.
When the DVD player's splash screen appears on your TV,
you're ready to go!
Select the VIDEO INPUT on your TV
4
TM
Pr/Cr
PROGRESSIVE SCAN
COMPONENT VIDEO OUT
COMPONENT VIDEO OUT
Pb/Cb
Y
VIDEO
S-VIDEO
L
R
COAXIAL
TV
ANTENNA / CABLE IN
CH-DVD 300
VIDEO R - AUDIO - L
Plug the DVD player's electrical
plug into a wall socket or power
strip.
strip.
Plug-in the Power Cord
2
Turn on the DVD Player and your TV
3
Press the POWER BUTTON on the front panel to turn the
DVD player on. The POWER LED should now change
from RED (STANDBY MODE) to GREEN (ON).
from RED (STANDBY MODE) to GREEN (ON).
POWER LED