UsGlobalSat br-305 Supplementary Manual
Then you may re-select the "Settings" selection to close configurations window.
Select "Monitor" from the selections, a small window will appear with raw NMEA data strings
displayed across at a rate of less than one second intervals.
Select "Monitor" from the selections, a small window will appear with raw NMEA data strings
displayed across at a rate of less than one second intervals.
Select "Satellites" a real-time window satellite information can be viewed. Within two-minute window
period, your first GPS fix should be acquired. This Satellites window will provide the user with real-
time satellite visibility and green graphical signal strength representation from real-time satellites
synchronization data. Note: Three satellites are required for two dimension positioning. Two
dimension positioning reports position only. Four satellites are required for three-dimension
positioning, that is to say position and elevation.
period, your first GPS fix should be acquired. This Satellites window will provide the user with real-
time satellite visibility and green graphical signal strength representation from real-time satellites
synchronization data. Note: Three satellites are required for two dimension positioning. Two
dimension positioning reports position only. Four satellites are required for three-dimension
positioning, that is to say position and elevation.
Route 66
Once verification of your hardware's performance is completed, exit GPS Utility program and proceed
by launching Route 66 application. Next, select the furthest right red icon (GPS status window) from
the horizontal listed icons. This action will provide you with a window, select "OK" to launch GPS
configuration window. Begin by selecting "Edit Properties", in result, GPS Properties will be displayed.
Set GPS connection settings to the following:
"/dev/cu. usbserial"
"4800"
by launching Route 66 application. Next, select the furthest right red icon (GPS status window) from
the horizontal listed icons. This action will provide you with a window, select "OK" to launch GPS
configuration window. Begin by selecting "Edit Properties", in result, GPS Properties will be displayed.
Set GPS connection settings to the following:
"/dev/cu. usbserial"
"4800"
This completes configurations needed for this application. Now, you may view the "status" field in the
GPS window with the real-time satellite acquisition status, in addition, to three dimensional
coordinates.
GPS window with the real-time satellite acquisition status, in addition, to three dimensional
coordinates.