EchoStar d-2400 ip User Manual
Section 3
Digital Satellite Receiver
Page 3 - 1
©
2
002
E
c
hoS
tar
Inte
rnati
o
nal
C
o
rp
orat
io
n
A
ll
ri
g
hts
re
s
erved
3
INSTALLATION
1.
CONNECT YOUR EQUIPMENT
It is possible to connect the different equipment with the use of UHF coaxial cables,
SCART cables, and/or so called audio/video cables with RCA connectors.
SCART cables, and/or so called audio/video cables with RCA connectors.
C
ONNECTION WITH
UHF
COAXIAL CABLES
1. On the TV, find the UHF-coaxial cable that is connected to the terrestrial antenna or cable
network.
2. Remove the UHF-coaxial cable from the TV and make sure the cable condition is OK.
3. On the rear panel of the receiver find the TV OUT connector.
4. Install an UHF-coaxial cable between the TV OUT connector (receiver) and the antenna
connector (TV).
5. On the rear panel of the receiver find the ANT IN connector.
6. Install the UHF-connector (terrestrial antenna) to the ANT IN connector (receiver).
C
ONNECTION WITH
SCART
CABLES
1. On the TV find the SCART cable that is connected to the VCR.
2. Remove the SCART connector that is connected to the VCR from the TV.
3. On the rear panel of the receiver find the TV and VCR SCART connectors.
4. Install a full featured SCART cable between the VCR and the VIDEO SCART connector
(receiver).
5. Install a full featured SCART cable between the TV SCART connector (receiver) and the
SCART connector on the TV (old SCART connection to the VCR).
C
ONNECTION
W
ITH
A
UDIO
/
VIDEO CABLE
(RCA-
CONNECTORS
)
1. On the rear panel of the receiver find the VIDEO, AUDIO L and AUDIO R connectors.
2. Install an audio/video cable between:
a.
the VIDEO connector of the receiver and TV (yellow);
b.
the AUDIO L connector of the receiver and TV (white);
c.
the AUDIO R connector of the receiver and TV (red).
C
ONNECTION WITH
D
OLBY
D
IGITAL AUDIO CABLE
(RCA-
CONNECTORS
)
1. On the rear panel of the receiver find the S/PDIF connector.
2. Install an audio/video cable (black) between:
a.
the S/PDIF connector (receiver) and Dolby Digital connection of the Dolby digital
compatible installation.
compatible installation.
C
ONNECTION WITH SERIAL CABLE
(0-
MODEM CABLE
)
1. On the rear panel of the receiver find the SERIAL PORT connector.
2. Install a serial cable between the SERIAL PORT connector (receiver) and the serial port
connection of the PC.
WARNING
ALL EQUIPMENT INVOLVED IN THE INSTALLATION TASK MUST BE INSTALLED CORRECTLY
AND SWITCHED OFF
. M
AKE SURE THAT IT IS SAFE TO PROCEED WITH THE INSTALLATION
TASK
. U
NSAFE CIRCUITS AND INSTALLATIONS CAN CAUSE
(
SERIOUS
)
INJURY OR DAMAGE
TO EQUIPMENT
.