Yamaha RX-497 User Guide

You can control other components by setting the 
appropriate remote control codes. Codes can be set up for 
each input source. For a complete list of available remote 
control codes, refer to “LIST OF REMOTE CONTROL 
CODES” at the end of this manual.

The following table show the default component category 
(Library) and the remote control code for each input 
source.

*

You can only set the TV remote control codes for the DTV/
CBL button. However, other remote control codes can be set 
for any input selector buttons except DTV/CBL.

You may not be able to operate your other YAMAHA 
components even if the YAMAHA remote control code is 
initially set as listed above. In this case, try setting other 
YAMAHA remote control codes.

You must press and hold CODE SET throughout this operation.

While holding down CODE SET on the 
remote control, use the numeric buttons on 
the remote control to enter the three-digit 
remote control code for the selected input 
source.
When the setting succeeds, “PRESET OK” appears; 
however, when it does not, “PRESET NG” appears in 
the front panel display.
To reset the code, enter the default code for each 
input source listed in the remote control code default 
settings table.

• If the manufacturer of your component has more than one code, 

try setting each of them until you find the correct one.

• You can only assign one remote control code to each input 

selector button.

CD

YAMAHA

199

TAPE

YAMAHA

499

DVD

YAMAHA

699

DTV/CBL*

—

—

—

—

—

—

—

—

—