Yamaha RX-N600 Owner's Manual

This section describes the function of each control on the remote control used to control this unit. To operate other 
components, see “REMOTE CONTROL FEATURES” on page 93.

• The operation mode of the remote control buttons in the shaded area below depends on the component selector switch position. Set the 

component selector switch to AMP to control this unit. To control the TUNER functions, set the component selector switch to 
SOURCE and then press TUNER to select “TUNER” as the input source.

• The XM Satellite Radio controlling functions in the following buttons (XM, XM MEMORY, SRCH MODE, DISPLAY, cursor 

buttons u / d / j / i, numeric buttons and ENT.) are only applicable to the U.S.A. and Canada models and are operational only when 
“XM” is selected as the input source. For details, see “XM Satellite Radio controls and functions” on page 55.

■

Set the component selector switch to AMP to control this 
unit.

1

Outputs infrared control signals. Aim this window at the 
component you want to operate (see page 8).

2

Use to set up remote control codes (see page 95).

3

Select the input source you want to control.

The corresponding input selector button for the currently selected 
input source lights up for approximately 5 seconds after you press 
any buttons on the remote control, showing which source 
component is currently being operated.

4

Select sound field programs (see page 65).
– Use SELECT to play back 2-channel sources in 

surround (see page 43).

– Use EXTD SUR. to switch between 5.1 and 

6.1-channel playback of multi-channel sources 
(see page 42).

– Use DIRECT ST. to play back 2-channel sources in 

hi-fi stereo sound (see page 39).

5

Turns on or off the set of front speakers connected to the 
FRONT A and/or B terminals on the rear panel. Press this 
button repeatedly to toggle as follows:

L

K

0

A
B

C

D

F

E

G

H
I

J

1

2

3

4

5
6

8

9

7