Yamaha RX-V1065 User Guide

Although the field sound programs would satisfy you as 
they are with the default parameters, you can arrange 
sound effect or decoders suitable for acoustical conditions 
of sources or rooms by setting the parameters.

y

• You cannot configure the parameters when “Memory Guard” is set to 

Press iON SCREEN on the remote control.
The GUI screen appears on the video monitor.

Press jCursor n to select “Setup” and then 
press jENTER.

Press jCursor k / n to select “DSP 
Parameter” and then press jENTER.

Press jCursor k / n to select “Program 
Name” and then press jCursor l / h to 
select a sound field program to edit.

Press jCursor k / n to select a parameter to 
edit and then press jCursor l / h to 
change the setting. 
For details on functions and adjustable ranges of the 
sound field parameters, see “Sound field parameters” 
on this page.

y

• Repeat steps 5 and 6 to change other sound field program 

parameters.

To turn off the GUI screen, press iON 
SCREEN.

y

• The default settings are marked with “*”.

Fine adjusts an effect level (level of the sound field effect 
to be added). You can adjust the level of the sound field 
effect while checking sound levels. Adjust “DSP Level” as 
follows.
• The effect sound is too soft.
• There are no differences between effects of the sound 

field programs. 
→Increase the effect level.

• The sound is dull.
• The sound field effect is added too much. 

→Reduce the effect level.

Use this feature to adjust the vertical position of the 
dialogues in movies. The ideal position of the dialogues is 
at the center of the video monitor screen.

If the dialogues are heard at the lower position of the video 
monitor screen, increase the value of “Dialogue Lift”.

When the value is set to zero, the position is at the lowest. 
The position gets higher as you increase the value.

• This setting is available only when “Extra Speaker Assignment” is set to 

“Presence” (page 56).

• You cannot move the dialogue position down from the initial dialogue 

position.

When CINEMA DSP 3D is enabled, sets whether to use 
sound field programs in 3D mode.

To initialize the parameters of the selected sound field 
program, press jCursor n repeatedly to select 
“Initialize” and then press jCursor h. Then, press 
jCursor

h again to execute the initialization or 

jCursor

l to cancel it.

Adjustable range: –6dB to 0dB* to +3dB

0* to 5

On*, Off