Yamaha RX-V2700 Owner's Manual

■

You can program your own macro and use the macro 
programming feature to transmit several remote control 
commands in sequence at the press of a button. Be sure to 
set up remote control codes or perform learning operations 
before programming the macro.

• The default macro is not cleared when a new macro is 

programmed for a button. The default macro can be used again 
when the programmed macro is cleared.

• It is not possible to add a new signal (macro step) to the default 

macro. Programming a macro changes all macro contents.

• We do not recommend programming continuous operations 

such as volume control in a macro.

“MCR ?” appears in the display window on the 
remote control.

If you do not complete each of the following steps within 30 
seconds, the macro programming mode will be 
automatically canceled. In this case, start over from step 1.

The macro button name (ex. “M;DVD”) and the 
selected component name (ex. “DVD”) appear 
alternately in the display window on the remote 
control.

“AGAIN” appears in the display window if you press a 
button other than a macro button.

You can set up to 10 steps (10 functions). After you 
have set 10 steps, “FULL” appears and the remote 
control automatically exits the macro mode. The 
following example is for programming the following 
procedure:
Step 1 (“MCR 1”): Press DVD.
Step 2 (“MCR 2”): Press AV POWER.
Step 3 (“MCR 3”): Press SLEEP.

To change the selected input area, press SELECT k

 / n

. 

Pressing the input selector buttons will program a macro step, 
whereas SELECT k

 / n

 only changes the selected input area.

“ERROR” appears in the display window if you press more 
than one button simultaneously.