Yamaha RX-V2700 Owner's Manual
32
En
CONNECTIONS
■
Connecting the AC power cable
Use the supplied AC cable. Do not use other AC power cables as doing so may result in fire or
electrical shock.
electrical shock.
Plug the supplied AC power cable into the AC inlet after all other connections are complete, then plug the AC power
cable into an AC wall outlet.
cable into an AC wall outlet.
■
VOLTAGE SELECTOR
(Asia and General models only)
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of
this unit must be set for your local voltage
BEFORE plugging the power cable into the AC
wall outlet. Improper setting of the VOLTAGE
SELECTOR may cause damage to this unit and
create a potential fire hazard.
this unit must be set for your local voltage
BEFORE plugging the power cable into the AC
wall outlet. Improper setting of the VOLTAGE
SELECTOR may cause damage to this unit and
create a potential fire hazard.
Rotate the VOLTAGE SELECTOR clockwise or
counterclockwise to the correct position using a
straight slot screwdriver.
counterclockwise to the correct position using a
straight slot screwdriver.
Voltages are as follows:
.............................. 110/120/220/230–240 V AC, 50/60 Hz
■
AC OUTLET(S) (SWITCHED)
U.K. and Australia models..................................... 1 outlet
Korea model............................................................... None
Other models......................................................... 2 outlets
Korea model............................................................... None
Other models......................................................... 2 outlets
Use these outlet(s) to supply power to any connected
components. Connect the power cable of your other
components to these outlet(s). Power to these outlet(s) is
supplied when this unit is turned on. However, power to
these outlet(s) is cut off when this unit is turned off. For
information on the maximum power or the total power
consumption of the components that can be connected to
these outlet(s), see “SPECIFICATIONS” on page 155.
components. Connect the power cable of your other
components to these outlet(s). Power to these outlet(s) is
supplied when this unit is turned on. However, power to
these outlet(s) is cut off when this unit is turned off. For
information on the maximum power or the total power
consumption of the components that can be connected to
these outlet(s), see “SPECIFICATIONS” on page 155.
Connecting the power cable
CAUTION
AC IN
AC OUTLETS
(U.S.A. model)
To the AC wall outlet
CAUTION
230-
240V
VOLTAGE
SELECTOR
Voltage indication
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power
cable is disconnected from the AC wall outlet or if the
power supply is cut off for more than one week.
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power
cable is disconnected from the AC wall outlet or if the
power supply is cut off for more than one week.