Yamaha RX-V300K Owner's Manual

10

Be sure to switch this only when the power of this unit is turned
off. 
Select the position whose requirements your speaker system
meets.

IF THIS UNIT FAILS TO TURN ON WHEN THE POWER
SWITCH IS PRESSED
The IMPEDANCE SELECTOR switch may not be set to
either end closely. If so, set the switch to either end closely.

(Upper position)

If you use one rear speaker, the impedance of the
speaker must be 6

Ω

or higher.

If you use two rear speakers, the impedance of each
speaker must be 3

Ω

or higher.

Center: The impedance of the center speaker must be 6

Ω

or

higher.

If you use one pair of main speakers, the impedance
of each speaker must be 4

Ω

or higher.

If you use two pairs of main speakers, the impedance
of each speaker must be 8

Ω

or higher.

(Lower position)

If you use one rear speaker, the impedance of the
speaker must be 8

Ω

or higher.

If you use two rear speakers, the impedance of each
speaker must be 4

Ω

or higher.

Center: The impedance of the center speaker must be 8

Ω

or

higher.

If you use one pair of main speakers, the impedance
of each speaker must be 8

Ω

or higher.

If you use two pairs of main speakers, the impedance
of each speaker must be 16

Ω

or higher.

Ω

Ω

Ω

Ω

Ω

Ω

Ω

Ω

Ω

Ω

(General model)

Use these to connect the power cords from your components
to this unit.
The power to the SWITCHED outlets is controlled by this unit’s
POWER switch or the provided remote control transmitter’s
POWER key.  These outlets will supply power to any
component whenever this unit is turned on.
The maximum power (total power consumption of components)
that can be connected to the SWITCHED AC OUTLETS is 100
watts.

Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases better
results may be obtained with the ground wire disconnected.

*

1

*

2