Yamaha RX-V3900 User Guide

Use this feature to save and recall up to six of your favorite 
setting for the main zone. You can also save up to four of 
your favorite settings for Zone 2 or Zone 3.

■ Saving by the 7SYSTEM MEMORY 

You can save the system settings stored in “Memory1” to 
“Memory4” by pressing the corresponding 7SYSTEM 
MEMORY buttons.

Press and hold one of the 7

SYSTEM MEMORY 

buttons on the remote control for 4 seconds.
“Memory1 SAVE” (example) appears in the front panel 
display, and then this unit saves the current system setting 
to the corresponding memory number.

y

• If system settings are already stored in the selected memory 

number, this unit overwrites the old settings.

• To save the system settings for Zone 2 or Zone 3, press 

HZONE on the remote control repeatedly to select the desired 
zone and then press and hold one of the 7SYSTEM 
MEMORY buttons for 4 seconds. To save the system settings 
for the selected zone, the zone should be turned on.

• This unit saves the parameters in the groups you select by using 

the GUI menu when you save the parameters by using the 
7SYSTEM MEMORY buttons.

■ Saving by the GUI menu operation

You can save the current system settings stored in 
“Memory1” to “Memory6” by using the “System 
Memory” menu in the GUI menu.

Set the operation mode selector on the 
remote control to F

AMP and then press 

I

MENU.

y

If the menu directory other than “Top Menu” (page 79) is 
displayed, press and hold IMENU to display the top GUI 
menu.

Press 9k / n repeatedly to select “Setup” 
and then press 9h.

Press 9k / n repeatedly to select “System 
Memory” and then press 9h.

Press 9k / n repeatedly to select the desired 
zone and then press 9h.

Press 9k / n repeatedly to select “xxx Save” 
and then press 9h.
“xxx” indicates the zone you selected in step 4.

Press 9 k / n repeatedly to select the 
desired memory number and then press 
9

ENTER.

The list of the parameter groups to be saved appears. 
Available parameter groups vary depending on the 
selected zone.

y

• If system settings are already stored in the selected memory 

number, this unit overwrites the old settings.

• To load the system settings with the 7SYSTEM MEMORY 

button operation, use one of “Memory1” to “Memory4”.

Press 9k / n repeatedly to select the 
parameter group and then press 9

ENTER 

to check or uncheck the box.
Check the boxes for the parameter groups to be saved. 
For details on parameters to be saved, see 
“Parameters to be saved” (page 102).

Press 9k / n / l / h repeatedly to select 
“SAVE” and then press 9

ENTER to save 

y

To cancel the operation, select “CANCEL” and then press 
9ENTER.

Press I

MENU to turn off the GUI menu.