Yamaha RX-V3900 User Guide

■ Installing batteries in the remote control

 

• Change all of the batteries if you notice the following 

conditions:
– the operation range of the remote control decreases.
– the transmit indicator does not flash or its light becomes dim.

• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline and 

manganese batteries) together. Read the packaging carefully as 
these different types of batteries may have the same shape and 
color.

• If the batteries have leaked, dispose of them immediately. Avoid 

touching the leaked material or letting it come into contact with 
clothing, etc. Clean the battery compartment thoroughly before 
installing new batteries.

• Do not throw away batteries with general house waste; dispose 

of them correctly in accordance with your local regulations.

• If the remote control is without batteries for more than 2 

minutes, or if exhausted batteries remain in the remote control, 
the contents of the memory may be cleared. When the memory 
is cleared, insert new batteries, set up the remote control code 
and program any acquired functions that may have been 
cleared.

■ VOLTAGE SELECTOR

• y indicates a tip for your operation.
• Some operations can be performed by using either the 

buttons on the front panel or the ones on the remote 
control. In case the button names differ between the front 
panel and the remote control, the button name on the 
remote control is given in parentheses.

• This manual is printed prior to production. Design and 

specifications are subject to change in part as a result of 
improvements, etc. In case of differences between the 
manual and product, the product has priority.

• “AMASTER ON/OFF” or “3DVD” (example) 

indicates the name of the parts on the front panel or the 
remote control. Refer to the attached sheet or the pages at 
the end of this manual for the information about each 
position of the parts.

The VOLTAGE SELECTOR on the rear panel of this 
unit must be set for your local voltage BEFORE 
plugging the power cable into the AC wall outlet. 
Improper setting of the VOLTAGE SELECTOR may 
cause damage to this unit and create a potential fire 
hazard.
Rotate the VOLTAGE SELECTOR clockwise or 
counterclockwise to the correct position using a straight 
slot screwdriver.
Voltages are as follows:
   ........................AC 110/120/220/230–240 V, 50/60 Hz