Yamaha ns-c60 User Guide

■

●

Connect the push-type input terminals at the rear of
the speaker to the speaker output terminals of your
amplifier with the provided speaker cables.

●

One side of the speaker cable is marked by a white
line. Connect the  (+) terminals on both the amplifier
and the speakers using this white-marked side.
Connect the (–) terminals on both components
using the unmarked side of the cable. If connected
with reversed polarity, the sound will be unnatural
and lack bass.

Procedures:

➀

Press the tab on the terminal down, as shown in
the figure.

➁

Insert the bare wire end properly into the terminal
hole. [Remove approx. 5 mm (1/4”) insulation from
the speaker cable.]

➂

Remove your finger from the tab to allow it to lock
snugly on the cable’s wire end.

➃

Test the security of the connection by tugging
lightly on the cable at the terminal.

Type ......................2 way bass-reflex speaker system

Magnetic-shielding type (EIAJ)

Speaker Unit ..............8 cm cone woofer (JA0858) x 2

Tweeter (JA05S0) x 1

Input Terminal .............................................Push-type
Nominal Impedance.........................................6 ohms
Frequency Response ...........60 Hz – 20 kHz (–10 dB)
Nominal Input Power............................................40W
Music Input Power................................................80W
Sensitivity ...................................................88 dB/w/m
Dimensions (WxHxD)..................435 x 100 x 221 mm

(17-

1

/

8

” x 4” x 8-

11

/

16

”)

Weight.........................................2.2 kg (4 lbs. 13 oz.)
Accessories ............................Speaker cable (4m) x 1

Slip-prevention pad x 4

* Specifications subject to change without notice due

to product improvements.

* Care should be taken not to exceed the input power

values noted above.