Yamaha YST-FSW100 User Guide

Yamaha and the Electronic Industries Association’s Con-
sumer Electronics Group want you to get the most enjoy-
ment out of your equipment by playing it at a safe level 
— a level that lets the sound come through loud and 
clear without annoying blaring or distortion — and, most 
importantly, without damaging your sensitive hearing.

Since hearing damage from loud 
sounds is often undetectable until it is 
too late, Yamaha and the Electronic 
Industries Association’s Consumer 
Electronics Group recommend that you 
avoid prolonged exposure to excessive 
volume levels.

UNIT!
This product, when installed as indicated in the 
instructions contained in this manual, meets FCC 
requirements. Modifications not expressly approved by 
Yamaha may void your authority, granted by the FCC, to 
use the product.

2. IMPORTANT: When connecting this product to 

accessories and/or another product, use only high 
quality shielded cables. Cable(s) supplied with this 
product MUST be used. Follow all installation 
instructions. Failure to follow instructions could void 
your FCC authorization to use this product in the USA.

3. NOTE: This product has been tested and found to 

comply with the requirements listed in FCC 
Regulations, Part 15 for Class “B” digital devices. 
Compliance with these requirements provides a 
reasonable level of assurance that your use of this 
product in a residential environment will not result in 
harmful interference with other electronic devices.

This equipment generates or uses radio frequencies and, 
if not installed and used in accordance with the 
instructions in the user’s manual, may cause interference 
harmful to the operation of other electronic devices.

Compliance with FCC regulations does not guarantee that 
interference will not occur in all installations. If this product 
is found to be the source of interference, which can be 
determined by turning the unit “OFF” and “ON,” please try to 
eliminate the problem using one of the following measures:

• Relocate either this product or the device that is being 

affected by the interference.

• Utilize power outlets that are on different branch circuits 

(circuit breaker or fuse) or install AC line filter(s).

• In the case of radio or TV interference, relocate or reorient 

the antenna. If the antenna lead-in is 300 ohm ribbon lead, 
change the lead-in to a coaxial type cable.

If these corrective measures do not produce satisfactory 
results, please contact the local retailer authorized to 
distribute this product. If you cannot locate the appropriate 
retailer, please contact Yamaha Electronics Corp., U.S.A.; 
6660 Orangethorpe Ave; Buena Park, CA 90620.

The above statements apply ONLY to those products 
distributed by Yamaha Corporation of America or its 
subsidiaries.

If the socket outlets in the home are not suitable for the plug supplied with this appliance, it should be cut off and an 
appropriate 3 pin plug fitted. For details, refer to the following instructions.

Note: The plug severed from the mains lead must be destroyed, as a plug with bared flexible cord is hazardous if 
engaged in a live socket outlet.

IMPORTANT:
THE WIRES IN MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings 
identifying the terminals in your plug, proceed as follows: The wire which is coloured BLUE must be connected to 
the terminal which is marked with the letter N or coloured BLACK.  The wire which is coloured BROWN must be 
connected to the terminal which is marked with the letter L or coloured RED.  Making sure that neither core is 
connected to the earth terminal of the three pin plug.