Yamaha Soavo-1 Owner's Manual

English

SPEAKERS

–

CONNECTIONS TO YOUR AMPLIFIER

Amplifier

Soavo-1 (L)

This speaker system is capable of standard connections and bi-wired connections. Before making
connections, make sure that the amplifier is switched off.

■CONNECTIONS

• Connect the screw-type terminals at the rear of the

speakers to the speaker terminals of the amplifier with
the speaker cable (sold separately).

• Connect the (+) terminals on the amplifier and the

speakers using one side of the cable. Connect the (–)
terminals on both components using the other side of the
cable.

• Connect one speaker to the left (L) terminals of your

amplifier, and another speaker to the right (R) terminals,
making sure not to reverse the polarity (+, –). If one
speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.

How to connect the cables:

Loosen the knob.

Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.

Insert the bare wire into the hole.

Tighten the knob and secure the cables.
Test the firmness of the connection by pulling lightly on
the cables at the terminal.

Notes

• Do not let the bare speaker wires touch each other as

this could damage the speaker or the amplifier, or
both of them.

• Do not insert the insulation coating into the hole.

The sound may not be produced.

Standard connections

Jumper
cable

Leave the jumper
cables in place
when connecting.

Soavo-1 (R)

Speakers
terminals of
the amplifier

Loosen

Tighten

Insulation coating

Bare wire

01_EN_Soavo-1_URGT.p65

6/26/06, 9:36 AM