Kenwood KDC-C667 Instruction Manual
KDC-C717
KDC-C667
COMPACT DISC AUTO CHANGER
INSTRUCTION MANUAL
©B64-1801-20 (MW)
Troubleshooting Guide
Specifications
Specifications subject to change without notice.
Laser diode ..................................................................................................GaAlAs (
λ=780 nm)
Digital Filter ..............................................................................................8 Time Over Sampling
D/A Converter.......................................................................................................................1 bit
Spindle speed.............................................................................................500 ~ 200 rpm (CLV)
Wow & Flutter......................................................................................Below Measurable Limit
Frequency Response (±1 dB) ...............................................................................5 Hz ~ 20 kHz
Total harmonic distortion (1 kHz) ...................................................................................0.005 %
Signal to Noise Ratio........................................................................................................100 dB
Dynamic range ...................................................................................................................94 dB
Channel separation.............................................................................................................96 dB
Operating voltage ...........................................................................14.4 V (11 ~ 16 V allowable)
Current consumption ................................................................................0.8 A at Rated power
Dimensions (W
D/A Converter.......................................................................................................................1 bit
Spindle speed.............................................................................................500 ~ 200 rpm (CLV)
Wow & Flutter......................................................................................Below Measurable Limit
Frequency Response (±1 dB) ...............................................................................5 Hz ~ 20 kHz
Total harmonic distortion (1 kHz) ...................................................................................0.005 %
Signal to Noise Ratio........................................................................................................100 dB
Dynamic range ...................................................................................................................94 dB
Channel separation.............................................................................................................96 dB
Operating voltage ...........................................................................14.4 V (11 ~ 16 V allowable)
Current consumption ................................................................................0.8 A at Rated power
Dimensions (W
× H × D)
(KDC-C717)........................................250
× 80 × 176 mm (9-13/16 × 3-1/8 × 6-13/16 in.)
(KDC-C667)........................................250
× 64 × 176 mm (9-13/16 × 2-1/2 × 6-13/16 in.)
Weight (KDC-C717) ............................................................................................2.0 kg (4.4 LBs)
Weight
(KDC-C667) ............................................................................................1.8 kg (4.0 LBs)
When removing the CD changer, be sure to first eject a magazine then unplug the changer cord. Do
not forget to attach the transport screws before transporting the CD changer.
The CD changer may be damaged during transport if a magazine or CD is left inside it or the transport
screws are not attached.
not forget to attach the transport screws before transporting the CD changer.
The CD changer may be damaged during transport if a magazine or CD is left inside it or the transport
screws are not attached.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Sound skips due to vibra-
tion.
tion.
The disc changer mode
cannot be selected.
cannot be selected.
• The unit is mounted at a slant.
• Changer unit is mounted in an
• Changer unit is mounted in an
unstable place.
• The angle adjustment switches
are set improperly.
The O-N selection switch of the
disc changer is not set properly.
disc changer is not set properly.
• Mount the unit so that is level.
• Mount the unit in a stable place.
• Mount the unit in a stable place.
• Set the angle adjustment
switches to the correct posi-
tions.
tions.
Set the O-N selection switch to
"O" position.
"O" position.