Zhone 1740 shdsl User Guide
1740 SHDSL 2/4-Wire Router User’s Guide
3.5
Password Setup
There are two types of access privileges. A system ADMINISTRATOR is the only person that can
configure, change parameters, monitor, and read the performance and status of the system. A USER can
only monitor and read the status of the system. The password for access through the Web is the same as
for Telnet access.
configure, change parameters, monitor, and read the performance and status of the system. A USER can
only monitor and read the status of the system. The password for access through the Web is the same as
for Telnet access.
To set up a password, complete the following steps:
STEP 1 Click Change Password on the Basic menu bar.
STEP 2 Enter the passwords for Administrator and User, and confirm the new password by re-typing the
password again.
STEP 3 Click Apply to complete the settings and save the setting by entering the Save & Reboot screen
on the basic menu bar.
z
Terminal Type: When the router is connected to the DSLAM, select CPE. When the router is connect
to a router for point to point application, one of the devices should be set to CO with the other set to
CPE. The default setting is CPE.
to a router for point to point application, one of the devices should be set to CO with the other set to
CPE. The default setting is CPE.
z
Console Password: Disabled, a local user does not have to enter a password to enter the console
mode. Enabled, users who attempt to access the device from the console will be prompted for the
password.
password.
28 May 2005 1740-A2-GB20-20