Zebra 2824-z User Guide
32
TLP 2824-Z User Guide
980533-001 A
Operations & Options
Printing in Peel-Mode
Printing in Peel-Mode
The optional dispenser allows you to print in “peel-mode” where the label backing follows a
different path and the labels are presented one at a time for subsequent placement.
different path and the labels are presented one at a time for subsequent placement.
Before using peel-mode, you must send the programming commands to the printer.
^XA ^MMP ^XZ
^XA ^JUS ^XZ
^XA ^JUS ^XZ
Refer to your ZPL II Programmer’s Manual.
1.
Remove several labels from the backing material.
2.
Open the top cover.
3.
Open the dispenser door.
4.
Using a stylus, switch on the label-taken sensor.
5.
Insert the backing in front of the peel bar and behind the peel roller.
6.
Close the dispenser door.
7.
Close the top cover.
8.
Press the Feed button to advance the label.
9.
During the print job, the printer will peel off the backing and present a single label. Take
the label from the printer so it will print the next label.
the label from the printer so it will print the next label.