ZyXEL p-662h Quick Setup Guide

Prestige 662H/HW Series Quick Start Guide 

5

 

After you’ve made the connections, connect the power adaptor to a power supply and 
push in the power button to turn on the Prestige.  

The PWR/SYS LED blinks while performing system testing and then turns steady on if 
the testing is successful.  A LAN LED turns on if a LAN port is properly connected. 

CON/AUX 
switch 
CON/AUX 
port 

Only connect this port if you want to configure the Prestige using the 
SMT via console port see your User's Guide for details. 

Set this switch to the CON side to use the CON/AUX port as a console 
port for local device configuration and management. Connect the RJ-45 
end of the console cable to the console port of the Prestige and the 
other end to a serial port (COM1, COM2 or other COM port) on your 
computer. Your computer should have a terminal emulation 
communications program (such as HyperTerminal) set to VT100 
terminal emulation, no parity, 8 data bits, 1 stop bit, no flow control and 
9600 bps port speed. 

The console port is also an auxiliary WAN port. Push the CON/AUX 
switch to AUX and connect the CON/AUX port to your modem or TA. 

RESET 

You only need to use this button if you’ve forgotten the Prestige’s 
password. It returns the Prestige to the factory defaults (password is 
1234, LAN IP address 192.168.1.1 etc.; see your User’s Guide for 
details).