ZyXEL p-660hwp User Guide

 Chapter 3 Wizard Setup for Internet/Wireless Access

P-660HWP-Dx User’s Guide

The following table describes the fields in this screen.

2 The next wizard screen varies depending on what mode and encapsulation type you use. 

All screens shown are with routing mode. Configure the fields and click Next to 
continue. 

Figure 26   Internet Connection with PPPoE

Table 8   Internet Access Wizard Setup: ISP Parameters

Mode

From the Mode drop-down list box, select Routing (default) if your ISP allows 

multiple computers to share an Internet account. Otherwise select Bridge. 

Encapsulation

Select the encapsulation type your ISP uses from the Encapsulation drop-down list 

box. Choices vary depending on what you select in the Mode field.  
If you select Bridge in the Mode field, select either PPPoA or RFC 1483. 
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or 

PPPoE.

Multiplexing

Select the multiplexing method used by your ISP from the Multiplex drop-down list 

box either VC-based or LLC-based. 

Virtual Circuit 

ID

VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit. 

Refer to the appendix for more information.

VPI

Enter the VPI assigned to you. This field may already be configured.

VCI

Enter the VCI assigned to you. This field may already be configured.

Back

Click Back to go back to the previous screen.

Next

Click Next to continue to the next wizard screen. The next wizard screen you see 

depends on what protocol you chose above. 

Exit

Click Exit to close the wizard screen without saving your changes.