ZyXEL p-660hwp User Guide

 Chapter 5 WAN Setup

P-660HWP-Dx User’s Guide

Figure 45   Internet Connection (PPPoE)

The following table describes the labels in this screen.  

Table 20   Internet Connection

General

Name

Enter the name of your Internet Service Provider, e.g., MyISP. This information 

is for identification purposes only.

Mode

Select Routing (default) from the drop-down list box if your ISP allows multiple 

computers to share an Internet account. Otherwise select Bridge. 

Encapsulation

Select the method of encapsulation used by your ISP from the drop-down list 

box. Choices vary depending on the mode you select in the Mode field. 
If you select Bridge in the Mode field, select either PPPoA or RFC 1483. 
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET 

ENCAP or PPPoE.

User Name

(PPPoA and PPPoE encapsulation only) Enter the user name exactly as your 

ISP assigned. If assigned a name in the form user@domain where domain 

identifies a service name, then enter both components exactly as given.

Password

(PPPoA and PPPoE encapsulation only) Enter the password associated with the 

user name above.

Service Name

(PPPoE only) Type the name of your PPPoE service here.

Multiplexing

Select the method of multiplexing used by your ISP from the drop-down list. 

Choices are VC or LLC.

Virtual Circuit ID

VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual 

circuit. Refer to the appendix for more information.