Sharp MX-M260 User Manual
133
TROUBLESHOOTING AND MAINTENANCE
7
MISFEED IN THE UPPER EXIT AREA
(when a job separator tray kit or finisher (MX-FN13) is installed)
(when a job separator tray kit or finisher (MX-FN13) is installed)
If a job separator tray kit or a finisher is installed, a misfeed may occur in the upper exit area.
1
Open the upper right side cover.
2
Gently pull the misfed paper out.
Be careful not to tear the
misfed paper during
removal.
misfed paper during
removal.
3
Close the upper right side cover.
Make sure that the misfeed message is cleared.
MISFEED IN AN OUTPUT TRAY
(when a finisher (MX-FN13) is installed)
(when a finisher (MX-FN13) is installed)
1
Open the front cover.
2
While pressing the lever over to the
left, slide the finisher to the left until it
stops.
left, slide the finisher to the left until it
stops.
Gently slide the finisher
until it stops.
until it stops.
3
Turn roller rotating knob in the
direction of the arrow to remove the
misfed paper.
direction of the arrow to remove the
misfed paper.
4
Slide the finisher back to the right.
5
Close the cover.
MX-M310.book 133 ページ 2009年7月6日 月曜日 午後6時57分