Sharp XG-C330X Operating Guide

-50

Menu operation

Page

When System Lock is set

When System Lock is set, the keycode in-
put screen appears after the power is turned
on.
When it appears, enter the right keycode to
start projection. Failure to enter the keycode
will cause images not to be projected even
when signals are entered to the projector.

▼Input screen for keycode

Note

• If no keycode is entered, the image will not be

displayed, even if the projector receives the in-
put signal.

Using the “Options1” Menu

Info

• You can activate the keylock function only

when no on-screen display is shown.

Locking the Operation Buttons on

the Projector (Keylock Function)

Use this function to lock the operation but-
tons on the projector.

■ Locking the Operation Buttons

Hold down

ENTER on the projector for about

5 seconds while the projector is being turned on.

▼On-screen Display

Keylock function ON

• The keylock function does not affect the opera-

tion with the remote control buttons.

• You cannot use the keylock function while the

projector is warming up.

■ Taking the Keylock Off

Hold down

ENTER on the projector for about

5 seconds.

▼On-screen Display

Keylock function OFF

• When the projector is in standby mode, you can

release the keylock by holding down

ENTER

and

STANDBY/ON on the projector simul-

taneously for about 5 seconds.

Description

The projector automatically turns on
when the power cord is plugged into the
AC outlet or the breaker switch is
turned on.
The projector is turned on manually
(see page

), and does not turn on

automatically when the power cord is
plugged into the AC outlet or the
breaker switch is turned on.

Selectable items
Enable

Disable

Direct Power On Function