Amana ndg6800aww Installation Instruction
Automatic Dryer
Instructions
Important to Installer
•
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE STARTING TO INSTALL THE
DRYER. THESE INSTRUCTIONS SHOULD BE RETAINED FOR FUTURE REFERENCE.
• REMOVE THE DOOR FROM ALL DISCARDED APPLIANCES TO AVOID THE DANGER OF A CHILD
SUFFOCATING.
• PROPER INSTALLATION IS THE RESPONSIBILITY OF THE OWNER.
• SERVICE CALLS PERFORMED AS A RESULT OF POOR SET-UP, ADJUSTMENT AND CONNECTION
ARE THE RESPONSIBILITY OF THE INSTALLER.
Make sure you have everything necessary for proper installation.
1. GROUNDED ELECTRICAL OUTLET is required. See Electric Requirements.
2. POWER CORD for electric dryers (except Canada).
3. GAS LINES (if a gas dryer) must meet National and Local Codes.
4. EXHAUST SYSTEM – must be rigid metal or flexible stiff walled metal exhaust ducting. See Exhaust Requirements.
1. GROUNDED ELECTRICAL OUTLET is required. See Electric Requirements.
2. POWER CORD for electric dryers (except Canada).
3. GAS LINES (if a gas dryer) must meet National and Local Codes.
4. EXHAUST SYSTEM – must be rigid metal or flexible stiff walled metal exhaust ducting. See Exhaust Requirements.
The dryer should be located to permit adequate room in front for
loading the dryer, and sufficient room behind the dryer for the
exhaust system.
loading the dryer, and sufficient room behind the dryer for the
exhaust system.
This dryer is factory-ready for rear exhaust. To exhaust out the
bottom or left side, use the accessory exhaust kit #12001453
(see Accessories). Instructions are included with the kit.
bottom or left side, use the accessory exhaust kit #12001453
(see Accessories). Instructions are included with the kit.
It is important to make sure the room has adequate make-up air.
The area where the dryer is located must not obstruct the flow of
combustion or ventilating air.
The area where the dryer is located must not obstruct the flow of
combustion or ventilating air.
On gas dryers, adequate clearance as noted on the data plate must
be maintained to insure adequate air for combustion and proper
operation of the dryer.
be maintained to insure adequate air for combustion and proper
operation of the dryer.
REQUIREMENTS
C A U T I O N
THE DRYER MUST NOT BE INSTALLED OR STORED
IN AN AREA WHERE IT WILL BE EXPOSED TO
WATER AND/OR WEATHER. THE DRYER AREA IS TO
BE KEPT CLEAR AND FREE FROM COMBUSTIBLE
MATERIALS, GASOLINE AND OTHER FLAMMABLE
VAPORS AND LIQUIDS. A DRYER PRODUCES
COMBUSTIBLE LINT. THE AREA AROUND THE
DRYER SHOULD BE KEPT FREE OF LINT.
GENERAL
LOCATION CONSIDERATIONS
DRYER DIMENSIONS
1 1
/2"
(3.8
1 c
m)
27"
(68.5
cm
)
13 1
/2"
(34.3
cm
)
3 1/4
"
(8.3 c
m)
2 7/1
6"
(6.2 c
m)
43
1/4
" m
in.
(10
9.9
cm
)
36
1/4
" m
in.
(92
cm
)
27
1/
2"
(69
.9 c
m)
22
1/
4"
(56
.5 c
m)
3 5/8”
(9.2 cm)
3 7/16”
(8.7 cm)
6 13/16”
(17.3 cm)
1 1/2" min.
(3.81 cm)
2