Amana AFD2535DES User Guide

5

2. While supporting door front,

hook supports into tabs
located on inside of rail.

1. Pull both rails out to full

extension.

3. Lower door front into

final position.

4. Place the basket cradles back onto the side rails.

Align snaps with the slots on the side rails and
press each snap toward the rail until it clicks.

5. With rails pulled out to full extension, set the

basket straight down into the basket cradles.

6. Slide upper basket into freezer. Make sure that rear

of basket hooks behind rail catch.

Basket cradle

snap attachments

1.  Install hinge assemblies:

• Install top hinge loosely with 

5

⁄

16

” hex head

screws.

• Install center hinge with Phillips

screws.

2. Place hinge side of refrigerator door

on center hinge pin.

3. While holding refrigerator door

upright, tighten down top hinge
with 

5

⁄

16

” hex head driver.

4. Reconnect two-pin connector.

5. Replace top hinge covers.

Remove and discard handle packaging and tape.

1. The handles are to be oriented

as shown.

2. Align door handle clip with the

door studs.

If not installed, the handle is located in the

interior of the fresh food section or attached to the
back of your refrigerator.

4. Rotate the handle so that the

handle is flat against the door.

3. Ensure the large hole in the

mounting clip is positioned
down on both ends of the
handle.

• Phillips screwdriver
•

5

⁄

16

” hex head driver